Abstract
The micromachining process for very small cutting depth of 1 μm or less is not well understood in spite of the successful development of ultraprecision machining technology. Sliding along the clearance face of the tool due to elastic recovery of the workpiece and plowing due to the tool edge radius may become important in the micromachining range. To obtain a clear understanding of these two factors, an orthogonal cutting model, the round edge cutting model (RECM) was suggested.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
