On the hot-rolled recycled carbon steels: their oxide formation, pickling ability and scale adhesion

Abstract

Purpose The purpose of this study is to investigate the formation, pickling ability and adhesion of thermal oxide scales on the hot-rolled recycled steels produced from the medium and thin slabs. Because the scale on the steel produced from the medium slab was relatively thick of about 11 µm, it contained cracks after hot-rolling. Thus during pickling, the scale was uniformly attacked with the simultaneous dissolution of the inner scale because of the penetration of acid through cracks. However, the scale on the steel produced from the thin slab was thinner of about 6 µm and thus, nearly crack-free. The pickling solution thus attacked the scale surface uniformly. At longer pickling periods, pits were also nucleated and propagated. Concurrently, the tensile testing machine with a CCD camera has been applied to observe scale adhesion. Design/methodology/approach The formation, pickling ability and adhesion of thermal oxide scales on the hot-rolled recycled steels produced from the recycled slab, e.g. medium slab and thin slab, were investigated. The morphology and phase identification were examined by using scanning electron microscopy, X-ray diffraction and Raman spectroscopy. Furthermore, the adhesion behaviour of oxide scale was investigated by immersion test and tensile test with a CCD camera. Findings For the scale formation, it was found that the hematite and magnetite were formed on the hot-rolled recycled steels produced from the medium and thin slabs. For the immersion test, it was found that the scale on hot-rolled recycled steels produced from the medium slab was more difficult to be pickled as represented by the longer time for the complete pickling. This was consistent with the result of tensile test; the steel produced from the medium slab had better scale adhesion as represented by the higher strain initiating the first spallation of scale. Originality/value The effects of slab types and its alloying element were investigated to understand the scale adhesion behaviour. The empirical pickling mechanisms and the mechanical adhesion energy were proposed. It led to the understanding in the control of alloying element in the hot-rolled steel.