On ensuring dynamic voltage stability of critical loads in the electric power systems of industrial facilities

Abstract

Listen

Translate article

Voltage sags and interruptions in the electric power systems (internal grids) of industrial facilities are caused by various short circuits, including those that occur in external grids. If the depth and duration of such sags and interruptions exceed the rated limits for critical loads, they cause continuous processes to shut down, which produces defective products and entails substantial losses. Russian standards and regulations do not set forth requirements with respect to voltage sags and interruptions, which means that industrial companies cannot sue grid operators for damages. This is why dynamic voltage stability of critical loads involved in continuous processes has to be addressed within the internal grid. They analyze the effectiveness of solutions designed for dynamic voltage stability of critical loads; these can be shared, used on a single site or designed to power secondary circuits. It shows that use of dynamic voltage restorers (DVR) and dynamic voltage sag correctors (DVSC) can be a cost- effective solution if the topology and specifications are configured appropriately. The paper presents general technical requirements for sag and interruption compensators, which are adjusted for cost-effectiveness. Case-specific feasibility testing should be based on daily readings of electrical parameters and electric power quality readings, calculated electromechanical transients, and a feasibility study. Use of DVRs at an industrial facility helped stabilize the voltage curve and reduce the span of irregular voltage fluctuations by a factor of 3, reduce the average voltage at the 6 kV busbars without compromising equipment performance, and improve the starting conditions for AM clusters and self-starting conditions for large AMs. Thus, lowering the elevated voltage at the 6 kV busbars helped cut electricity purchase costs. In most cases where accidents cause disturbances in the external 110 kV grid, DVRs coupled with the automatic voltage controls of power transformers were able to prevent process shutdowns, which constituted the key cost effect.