Abstract
Purpose of the work – to study of the processes that determine the interaction of non-metallic inclusions and the steel matrix during steel rolling. Methods. The behavior of inclusions was studied during hot rolling of steels 08Yu, 08T, 08kp, NB-57, 08GSYUTF in the temperature range of 1 200...900 °C and cold rolling with degrees of deformation of 35...75 %. The study of hot slipping along the boundaries of the inclusion − matrix was observed during high-temperature (900...1 200 °C) deformation by stretching in a vacuum on the IMASH-5S installation with a gripper movement speed of 1 680 mm/min. According to the study of slipping, steel samples were stretched in a vacuum at temperatures of 25...900 °С on the IMASH-5S installation with a gripper movement speed of 2 000 mm/min. On the surface of the samples, using the PMT-3 device, reference points were applied near the 0° and 90° inclusion poles on both sides of the inclusion − matrix boundary. Research methods are given in works [10; 11]. Identification of inclusions was carried out by metallographic (Neophot-31), petrographic and micro-X-ray spectral (MS-46 Cameca) methods. Results. It is shown that during plastic deformation, there is an interaction between non-metallic inclusions and the steel matrix, which determines their joint plastic shape change and is associated with the development of competing processes at the inclusion − matrix interphase boundaries: interphase friction and slipping (hot or cold depending on the deformation temperature). The mechanisms of these processes are determined depending on the deformation conditions and the level of plasticity of non-metallic inclusions and the steel matrix. Scientific novelty. The peculiarities of interphase friction and hot and cold slipping along the inclusion − matrix interphase boundaries of steel under different conditions of plastic deformation have been established. It is shown that the mechanisms of each of these processes depend on the temperature regime of deformation, the level of plasticity of the inclusions and the steel matrix, as well as on the structure of the inclusion − matrix boundaries, which determines the possibilities of movement and interaction of interfacial defects. It is shown that the specified processes determine the level of plasticity of the inclusion − matrix boundaries and significantly affect the nature of the change in shape of the inclusions and their redistribution in the steel matrix during steel rolling, which inevitably affects the technological plasticity of steels. Practical significance. The use of the results obtained will make it possible to develop technologies for producing steels with regulated types of nonmetallic inclusions, which will significantly increase their technological characteristics, as well as prevent the formation of various kinds of defects during the processing of steels by pressure of products.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.