Occurrence and composition of extracellular lipids and polysaccharides in a full-scale membrane bioreactor

Abstract

The aim of this study was to characterize the polysaccharides and lipid fractions of membrane foulants in a full-scale membrane bioreactor (MBR) treating municipal wastewater. Both of these polymeric compounds are major components of bacterial lipopolysaccharides and are impacting membrane fouling; however most of the data so far have been collected by determining sum parameters rather than the detailed composition of these polymers. Photometric analysis of sugars showed that uronic acids (glucuronic, mannuronic and galacturonic acid) as common units of bacterial polysaccharides accounted for 8% (w/w) of extracellular polymeric substances (EPS) in activated sludge flocs. Further the so-called polysaccharide peak of EPS, with a molecular weight >10 kDa according to size exclusion chromatography, was proven to contain bacterial sugar units as shown by high resolution LC–MS. Interestingly, only traces of uronic acids could be detected in EPS of the membrane fouling layer. A far more dramatic enrichment in the fouling layer was revealed for the lipid fraction of EPS, which was determined as fatty acid methyl esters by GC–MS. The weight percentage of fatty acids in EPS extracted from fouled ultrafiltration membranes was much higher (10%) than in the activated sludge itself (1–3%). The fatty acids accumulated on the membrane fouling layer were obviously not only of microbial origin (C16:0, C18:0) but also derived from the raw wastewater itself (C9:0). Hydrophobic interaction of lipids with the PVDF (polyvinylidene fluoride) membrane material therefore seems a plausible explanation for the observed fouling phenomenon. The results suggest that fatty acids from bacterial lipopolysaccharides as well as from synthetic sources are of much higher relevance to membrane fouling than previously assumed.