Insight into the distribution of metallic elements in membrane bioreactor: Influence of operational temperature and role of extracellular polymeric substances.

Abstract

The distribution of metallic elements in a submerged membrane bioreactor (MBR) was revealed at different temperatures using inductively coupled plasma-optical emission spectrometry (ICP-OES), and the role of extracellular polymeric substances (EPS) was probed by integrating scanning electron microscopy (SEM) with confocal laser scanning microscopy (CLSM) over long-term operation. More metallic elements in the influent were captured by suspended sludge and built up in the fouling layer at lower temperature. The concentration of metallic elements in the effluent was 5.60mg/L at 10°C operational temperature, far lower than that in the influent (51.35mg/L). The total contents of metallic elements in suspended sludge and the membrane fouling layer increased to 40.20 and 52.19mg/g at 10°C compared to 35.14 and 32.45mg/g at 30°C, and were dominated by the organically bound fraction. The EPS contents in suspended sludge and membrane fouling layer sharply increased to 37.88 and 101.51mg/g at 10°C, compared to 16.87 and 30.03mg/g at 30°C. The increase in EPS content at lower temperature was responsible for the deposition of more metallic ions. The strong bridging between EPS and metallic elements at lower temperature enhanced the compactness of the fouling layer and further decreased membrane flux. This was helpful for understanding the mechanism of membrane fouling at different operational temperatures and the role of EPS, and also of significance for the design of cleaning strategies for fouled membranes after long-term operation.