Occlusal stress distribution and remaining crack propagation of a cracked tooth treated with different materials and designs: 3D finite element analysis

Abstract

ObjectiveHere we used 3D finite element analysis (FEA) to analyze and directly compare stress distribution and crack propagation in identical cracked tooth models after treatment with various materials and designs. MethodsA 3D model of a cracked tooth was generated. We then applied eight restoration models, comprising combinations of three kinds of restoration designs (inlay, onlay, and crown) and four types of restoration materials (direct composite resin, indirect composite resin, ceramic, and gold). A 1000-N occlusal load was applied on the three reference points of the ball-shaped part in the direction of the longitudinal axis, causing crack line separation in the buccolingual direction. Stress distribution was analyzed on the occlusal surface, bottom level of the restoration, and mesiodistal longitudinal section. The stress on the lower margin of the crack surface was measured at 15 points on each model. ResultsCeramic inlay and onlay showed stress concentration at the restoration bottom, and low stress on the lower margin of the crack surface. Direct and indirect resin restorations exhibited low stress on the restoration bottom, and high stress on the proximal end of the lower margin of the crack surface. With a resin-unfilled gold crown, stress was concentrated on the crown bottom and the lower margin of the crack surface. Direct resin filling inside the gold crown yielded significantly decreased stress on both areas. SignificanceOur results suggest that inlay and onlay ceramic restorations, and gold crown with resin filling inside, are advantageous methods for preventing further crack propagation.