Observer-based synchronization in complex dynamical networks with nonsymmetric coupling

Abstract

Based on a general complex dynamical network model with nonsymmetric coupling, some criteria for synchronization are proposed based on the approach of state observer design. Unlike the nonobserver-based dynamical networks, where the coupling between two connected nodes is defined by an inner coupling matrix and full state coupling is typically needed, in this paper, smaller amount of coupling variables or even only a scalar output signal of each node is needed to synchronize the network. Unlike the commonly researched complex network model, where the coupling between nodes is symmetric, here, in our network model, the coupling configuration matrix is not assumed to be symmetric and may have complex eigenvalues. The matrix Jordan canonical formalization method is used instead of the matrix diagonalization method, so in our synchronization criteria, the coupling configuration matrix is not required to be diagonalizable. Especially, the proposed step-by-step approach is simpler in computation than the existent ones, which usually rely heavily on numerical toolbox, and may be done by hand completely. An example is given to illustrate the step-by-step approach, in which each node is a two-dimensional dynamical limit cycle oscillator system consisting of a two-cell cellular neural network, and numerical simulations are also done to verify the results of design.