Abstract
We present multiwavelength observations of a simple bipolar active region (NOAA 10953), which produced several small flares ( mostly B class and one C8.5 class) and filament activations from April 30 to May 3 in 2007. We also explore nonlinear force-free field (NLFFF) modeling of this region prior to the C8.5 flare on May 2, using magnetograph data from SOHO/MDI and Hinode/SOT. A series of NLFFF models are constructed using the flux-rope insertion method. By comparing the modeled field lines with multiple X-ray loops observed by Hinode/XRT, we find that the axial flux of the flux rope in the best-fit models is ( 7 +/- 2) x 10(20) Mx, while the poloidal flux has a wider range of (0.1-10) x 10(10) Mx cm(-1). The axial flux in the best-fit model is well below the upper limit (similar to 15 x 10(20) Mx) for stable force-free configurations, which is consistent with the fact that no successful full filament eruption occurred in this active region. From multiwavelength observations of the C8.5 flare, we find that the X-ray brightenings ( in both RHESSI and XRT) appeared about 20 minutes earlier than the EUV brightenings seen in TRACE 171 angstrom images and filament activations seen in MLSO H alpha images. This is interpreted as an indication that the X-ray emission may be caused by direct coronal heating due to reconnection, and the energy transported down to the chromosphere may be too low to produce EUV brightenings. This flare started from nearly unsheared flare loop, unlike most two-ribbon flares that begin with highly sheared footpoint brightenings. By comparing with our NLFFF model, we find that the early flare loop is located above the flux rope that has a sharp boundary. We suggest that this flare started near the outer edge of the flux rope, not at the inner side or at the bottom as in the standard two-ribbon flare model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.