Abstract
AbstractThis work has investigated filling characteristics during injection molding of a thin‐plate with microchannel patterns on it. To conduct molding experiments, an injection mold and mold inserts with microchannel patterns were designed and built. The experiments were conducted for three different channel sizes, and the results are analyzed. An unstable filling flow was observed in microscopic images for the smallest channel size. The front advanced with continuous creation and merge of microballs, which looked like teeth on the gum. We have analyzed this phenomenon and argued that there exists a critical channel width where such instability takes places. POLYM. ENG. SCI., 2010. © 2010 Society of Plastics Engineers
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.