Numerical study on the group wall effect of nodular diaphragm wall foundation in high-rise buildings

Abstract

Abstract As a new type of foundation, the nodular diaphragm wall (N-D wall) has large transverse stiffness and high bearing capacity, with low noise and low vibration, which is suitable for high-rise buildings in cities with limited land area. The reduction coefficient of each load composition under the same displacement conditions and the ABAQUS finite element numerical analysis software are introduced to analyze the group effect of N-D wall foundations. The results show that the compressive group wall effect coefficient is greater than 1, while the uplift group wall effect coefficient is less than 1. Under the same displacement condition, the group effect of the compressive wall is more obvious than that of the uplift wall, and the group effect of the middle wall is more obvious than that of the sidewall. The wall group effect gradually develops downward with the increase in displacement. The ultimate compressive capacity is mainly controlled by the friction resistance, which is especially obvious in the sidewall. The cap resistance load-sharing ratio decreases first and then increases with the settlement. The cap resistance is not evenly distributed, the stress at the corner is the lowest, and the stress is mainly concentrated in the middle. The influence of wall spacing, length, and width on the uplift bearing capacity is highly significant, while the influence of nodular part angle is slightly significant. The influence of wall width, length, and spacing on compressive bearing capacity is highly significant, while the influence of nodular part angle is weak. The influence of nodular part angle on the uplift bearing capacity of group wall foundation is stronger than that of the compressive bearing capacity.