Abstract
The long process of thin-walled conveying connecting pipe is simulated with mold filling and solidification process based on ProCAST software. The results show that the shrinkage of the connecting pipe opening of the body and the flange structure of casting pipe casting, The simulation results show that the shrinkage porosity of the pipe was located on body part and the flange structure, casting consistent with the actual experimental results. According to the simulation results, the structure of the gating system was optimized. The optimized scheme can reduce shrinkage from 30 to 10 cm3. The application of optimized pouring system is benefit to eliminating the shrinkage defect and increasing the casting yield.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: DEStech Transactions on Engineering and Technology Research
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
