Numerical Simulation and Experimental Study of Cold and Hot Composite Forming of Sharp-Edged High-Strength Steel Sections.

Abstract

This paper describes the use of cold and hot composite forming technology to produce pointed curtain wall profiles. An electromagnetic-temperature coupling model was constructed using ANSYS to study the temperature and electromagnetic field distribution during the forming process. Numerical simulation was used to optimize the process parameters to obtain the optimum heating parameters with a current of 4000 A, a frequency of 35 kHz, and a duration of 2 s. The accuracy of the model was also verified through experiments. The simulation results show that the use of a conductive magnet can improve the induction heating efficiency, increasing the heating frequency and the temperature peak; however, it also increases the temperature difference. Sharp-corner curtain wall profiles were successfully produced using the optimized process parameters. The temperature of the heating zone was measured using an infrared thermal imager, and the relative errors between the maximum heating temperature obtained from the simulation and the actual measured values were 5.37% and 5.02%, respectively, indicating that the finite element model performs well in terms of prediction.