Abstract
The development of growth processes for the synthesis of high-quality epitaxial layers is one of the requirements for utilizing the ultrawide band gap semiconductor Ga2O3 for high-voltage, high-power electronics. A halide vapor phase epitaxy (HVPE) process used to grow β-Ga2O3 layer was optimized by modifying the gas inlet, resulting in improved growth uniformity. A conventional tube acting as an inlet for the Ga precursor GaCl gas was replaced with a shower head with four outlets at 45 degrees to the horizontal axis of the reactor. The modification was performed based on numerical calculations of the three-dimensional distribution of gases inside the growth chamber with different designs of the GaCl precursor inlet. It was shown that variation in the Ga/O ratio over the substrate holder was ~10% for a shower head compared with ~40% for a tube. In addition, growth with a tube leads to the film thickness varying by a factor of ~4 depending on the position on the holder, whereas when using a shower head, the thickness of the grown Ga2O3 layers became much more uniform with a total spread of just ~30% over the entire substrate holder.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
