Abstract
Abstract In this article, a numerical model of the full surge cycle is presented for the low-speed centrifugal blower and compared with the experiment. Surge phenomenon is very dangerous for the compressor operation. Therefore, the possibility of studying its physics experimentally is strongly limited. The application of numerical methods allows one to safely analyze surge physics without causing risks to the operating crew. This article presents a description of the applied numerical method and exhaustive analysis of the flow structures observed at consecutive stages of the surge cycle. The surge is known to be very difficult to be simulated due to large timescale and region of influence. This study also shows the importance of an appropriate choice of the simulation definition and the boundary conditions. The presented method allows gathering information about features such as the regions of flow reversal, pressure distributions, pressure rise, cycle frequency, and others. All the aforementioned information provides important input to the efficient antisurge system design. The model has been validated by a comparison with the experimental data. Thanks to simulation, standardized antisurge solutions could be possibly replaced with more efficient protection schemes tailored to a given machine.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
