Abstract
AbstractIn this study, the authors study the impact of spherical dimple surfaces and nanofluid coolants on heat transfer and pressure drop. The main objective of this paper is to evaluate the thermal performance of nanofluids with respect to different Reynolds numbers (Re) and nanoparticle compositions in dimpled channel flow. Water‐based nanofluids with , CuO, and –CuO nanoparticles are considered for this investigation with 1%, 2%, and 4% volume fraction for each nanofluid. The simulations are conducted at low Reynolds numbers varying from 500 to 1250, assuming constant and uniform heat flux. The effective properties of nanofluids are estimated using models proposed in the literature and are combined with the computational fluid dynamics solver ANSYS Fluent for the analysis. The results are discussed in terms of heat transfer coefficient, temperature distributions, pressure drop, Nusselt number, friction factors, and performance criterion for all the cases. For all cases of different nanoparticle compositions, the heat transfer coefficient was seen as 35%–46% higher for the dimpled channel in comparison with the smooth channel. Besides, it was observed that with increasing volume fraction, the values of heat transfer and pressure drop were increased. With a maximum of 25.18% increase in the thermal performance, the 1% /water was found to be the best performing nanofluid at Re = 500 in the dimpled channel flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have