Abstract

Most studies on dynamic coefficients of bearings are focused on evaluation using different analytical methods. Minimal emphasis is given to the level of influence of each geometrical variable, the corresponding range of these variables for optimum stiffness and damping and the measure of performance of the analytical method used. The objective of this paper was to study the influence and sensitivity of length-to-diameter ratio, eccentricity ratio, bearing number, whirl ratio, and bearing compliance on the stiffness and damping of gas foil bearing. A numerical model is developed by utilizing the finite difference method to evaluate the dynamic coefficients. The results reveal that the normalized stiffness increases with the bearing number and decreases with increased bearing compliance whereas the normalized damping shows an opposite nature. Further, the stiffness coefficients tend to increase and the damping coefficients tend to decrease corresponding to increase in speed up to 240 krpm. The characteristic data sets obtained from the analysis is used to train an artificial neural network (ANN). Performance of ANN network is evaluated though computation of root-mean-square error (RSME) and regression coefficient (R2) and Mean Absolute Error (MAE). Utilizing the neural network results, a Sobol’s sensitivity test is carried out to identify most effective parameters which have a significant influence on the dynamic coefficients of gas foil bearing. After that, an adaptive neurofuzzy interface system (ANFIS) is established to determine the optimum range of data for which maximum stiffness and damping can be obtained. The results deduce that the neural network shows high efficacy in predicting the output variables correctly with a regression of more than 95%. It is also observed that the variation of dynamic coefficients is the highest for eccentricity ratio whereas lowest for whirl ratio. The maximum stiffness and damping coefficients are also obtained for a wide range of geometrical variables which can help in designing the gas foil bearing.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call