Abstract
The Savonius rotor is one of the simple and cost-effective vertical axis drag type devices for hydropower generation. The main drawback of the Savonius hydrokinetic turbine is its low performance due to negative torque developed by returning blade profile. In this paper, the performance of modified V-shaped rotor blades with different V-angles ranging from 90° to 40°, by maintaining fixed edge length, arc radius and aspect ratio of 0.7 is investigated. The numerical analysis is carried out to estimate the optimum V-angle by maintaining 70 mm depth of water with an inlet velocity of 0.3090 m/s. The numerical study revealed that, for 80° V-angle rotor blade profile, the maximum coefficient of power was found to be 0.2279 at a tip speed ratio of 0.9. This optimum V-angle model was used for experimental analysis to study the effect of aspect ratio ranging from 0.7 to 1.75 using top, middle and bottom plates by maintaining 140 mm depth of water and inlet velocity of 0.513 m/s. The rotor blade with two endplates and one middle plate with an aspect ratio of 1.75 has shown a significant increase of performance by 86.13% at a tip speed ratio of 0.86 as compared to turbine blade with two endplates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.