Abstract
In this paper, the impact of the anode contact in SBDs, PiN, JBS and MPS diodes is analyzed through TCAD simulations. The focus of the investigation is the correct simulation of the Schottky barrier height on the different areas of the device to correctly simulate a JBS or MPS structure. It is found that the splitting of the anode contact and an accurate selection of the Schottky barrier height on pzone is necessary to allow the onset of the bipolar conduction in MPS devices. In this way, it is possible to correctly analyze the behavior of an MPS diode, including the snapback phenomenon.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
