Abstract
This work aims to investigate the infiltration of a CaCO3filled resin in fibrous porous media (resin transfer molding process) using the PAM-RTM software. A preform of glass fiber mat (fraction 30%), with dimensions 320 x 150 x 3.6 mm, has been used in rectilinear injection experiments conducted at room temperature and injection pressure 0.25, 0.50 and 0.75 bar. The polyester resin contain 0% and 40% CaCO3. The numerical results were evaluated by direct comparison with experimental data. The flat flow-front profile of the rectilinear flow was reached approximately half length of the mold. It was observed, that the both velocity infiltration and permeability have decreased with increasing the CaCO3content, thus, increasing the time to processing of the composite material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.