Abstract
This article presents a numerical analysis of laser-welded flange pipe joints. The presented results concern the welding of low carbon S235JR and stainless 316L steels using a CO2 laser in lap and fillet joint configurations. The estimation of welding parameters was achieved using Simufact Welding software and numerical simulation, where output power, feed rate, efficiency and intensity distribution (Gaussian parameter) were analysed. In accordance with the established model, a thermo-mechanical simulation was performed. The calculated joint geometries show good agreement with experiments; therefore, the obtained results were used to study selected joint properties of both joint types. Stress-strain distribution was estimated on the basis of thermomechanical analysis. Weld bead geometry obtained from numerical simulation was compared with the results from trial joints. The numerical model established for both joint configurations shows good agreement with experimental results and were assumed to be accurate. The results of the performed analysis shown some advantages of the use of this configuration of lap joints in flange pipe joints.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
