Abstract

Nucleation enhancement in a highly stereodefective poly(l-lactide) (PLLA) with an optical purity of 88% by low-temperature pressure (0 and 35 °C under 2 MPa) CO2 preconditioning was investigated using differential scanning calorimetry (DSC), infrared (IR) spectroscopy, polarized optical microscopy (POM) as well as positron annihilation lifetime spectroscopy (PALS). Despite the preconditioning of the melt-quenched films for 2 h, IR results indicated that no trace of mesophase was generated and the samples remained in the glassy state. However, judging from the results of DSC, IR, and POM, when compared to the untreated sample, both the treated ones showed a significantly enhanced crystal nucleation effect, resulting in the corresponding greatly enhanced crystallization kinetics. Moreover, owing to the existence of the retrograde vitrification, the conditions of the previous low-pressure CO2 conditioning affected the nucleation enhancement effect. When compared to the case of 35 °C, the much lower temperature of 0 °C was more effective for nucleation enhancement. The PALS results indicated that the enlarged free volume, which resulted from the CO2 conditioning, largely accounted for the formation of locally ordered structures, providing many more potential nucleation sites for forming critical nuclei and thus the resulting enhanced crystallization kinetics in glassy PLLA. The present results have implications in understanding the nucleation enhancement effect, in particular in stereodefective PLLA systems, which possess extremely low crystallization ability and are thus probably too problematic to be evaluated by conventional methods.

Highlights

  • Poly(L-lactide) (PLLA) has attracted much attention, because it can be derived from renewable resources and because it has attractive properties such as biodegradability, high biocompatibility, and good processability [1,2]

  • The crystallization ability was unusually enhanced for the CO2 conditioned PLA samples (PLA-T0 and PLA-T35) even though they were just subjected to the low-pressure CO2 treatment at such a low temperature as 0 ◦ C for a short time of 2 h

  • We investigated the nucleation enhancement in a stereodefective PLLA with an optical purity of 88% by low-temperature pressure CO2 preconditioning

Read more

Summary

Introduction

Poly(L-lactide) (PLLA) has attracted much attention, because it can be derived from renewable resources and because it has attractive properties such as biodegradability, high biocompatibility, and good processability [1,2]. On the basis of previous report [18], we would like to emphasize that the short-time preconditioning by low-temperature CO2 under 2 MPa was insufficient to induce crystallization for a highly stereodefective PLLA with a low optical purity of 88%. A two-stage crystal development method could be used to understand the enhanced formation of crystal nuclei by the low-pressure/temperature CO2 conditioning. The thermal crystallization behavior of PLA after CO2 conditioning at 0 ◦ C and 35 ◦ C under 2 MPa was investigated at 110 ◦ C via differential scanning calorimetry (DSC), polarized optical microscopy (POM) as well as time-resolved Fourier transform infrared (FTIR) spectroscopy. We compared the nucleation enhancement effect of our low temperature pressure CO2 preconditioning with that of physical aging

Experimental
Results and Discussion
Summary of isothermal crystallization kinetics atto forCO
Summary of Crystallization
(Figures had
An increase in τ 3 is observed increase in τ3 isthe observed for PLA-T0 orthe
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call