Abstract
In spite of advantages of direct methanol fuel cells, low methanol oxidation reaction and fuel crossover from anode to cathode, there remains a challenge that inhibits it from being commercialized. Active electrocatalysts are in high demand to promote the methanol oxidation reaction. The methanol reached at the anode can be immediately reacted, and thus, less methanol to cross to the cathode. The performance of electrocatalysts can be significantly influenced by varying the concentration of precursor solution. Theoretically, concentrated precursor solution facilitates rapid nucleation and growth; diluted precursor solution causes slow nucleation and growth. Rapid nucleation and slow growth have positive effect on the size of electrocatalysts which plays a significant role in the catalytic performance. Upon the addition of appropriate concentration of graphene oxide, the graphene oxide was reported to have stabilizing effect towards the catalyst nanoparticles. This work synthesized reduced graphene oxide–supported palladium electrocatalysts at different concentrations (0.5, 1.0, 2.0, 3.0 and 4.0 mg mL−1) with fixed volume and mass ratio of reduced graphene oxide to palladium by microwave-assisted reduction method. Results showed that reduced graphene oxide–supported palladium synthesized at a concentration of 1.0 mg mL−1 gave the best methanol oxidation reactivity (405.37 mA mg−1) and largest electrochemical active surface area (83.57 m2 g−1).
Highlights
Depletion of fossil fuels in near future and its arisen pollution issue have sparked interest of scientists and engineers to seek for alternative energy supply.[1]
Planes of reduced graphene oxide (rGO), imply that GO sheets were successfully reduced by microwave irradiation for all samples.[20]
By keeping the ratio of Pd to rGO fixed at 1:1, Pd/rGOs of different concentrations were successfully synthesized by microwave reduction method in ethylene glycol (EG) solution
Summary
Depletion of fossil fuels in near future and its arisen pollution issue have sparked interest of scientists and engineers to seek for alternative energy supply.[1]. Nanomaterials and Nanotechnology electrolyte membrane into the cathode.[5] This results in reduced cell voltage (sometimes called a mixed potential), flow of internal currents and a waste of fuel.[6] A solution to this problem is to synthesize active anodic electrocatalysts. Active electrocatalysts allow the methanol reached at the anode to be reacted effectively. This will cause less methanol available to diffuse through the electrolyte to the cathode.[6]
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.