Novel methods for high-speed observation of material removal and molten pool movement in EDM

Abstract

This paper proposes two new methods to observe discharge phenomena without interference from the plasma in electrical discharge machining. The first method uses a bandpass filter with a bandwidth of 800–820 nm and laser illumination with a wavelength of 800–820 nm. The second method also uses a bandpass filter with a bandwidth of 800–820 nm; however, in this method, the tungsten material is used not only as the tool electrode but also as the illumination source. First, the discharge process was observed using traditional methods to investigate the influence of the plasma on the observation of the discharge process. Then, the process of removing molten material from both the tool electrode and workpiece, as well as molten pool movement, was observed using the first method proposed in this paper. The material removed from the tool electrode was scattered upward along the end profile of the tool electrode, while the material removed from the workpiece was distributed along the horizontal direction. To explain these phenomena, the flow distribution in the gap was qualitatively analyzed using a fluid simulation. Finally, the discharge process was also observed using the second method proposed in this paper. A tungsten tool electrode can emit light with a wavelength of 800–820 nm, which shines on the observed region during the discharge process. The observation results verified the phenomenon of multiple explosions of the molten pool during the discharge process. Moreover, it was found that the material removed by the explosion of the molten pool was scattered in different directions and hardly influenced by the flow distribution in the gap.