Abstract
The effect of ultraviolet light produced ozone and irradiation (UV/ozone) cleaning on the surface properties and interface electrical properties of 4 unit cell (uc) LaAlO3/SrTiO3 samples is examined. A standard photolithography process is used to contaminate the samples which are then cleaned in UV/ozone. Atomic force microscopy measurements show that the photoresist contaminated samples can be cleaned efficiently using this method. The surface roughness of the cleaned samples is comparable to that of the as-grown samples. Furthermore, electrical transport measurements show that the mobility decreases and the sheet carrier density increases for the contaminated samples, which also display indications of an onset to the Kondo effect. By removing the contaminants with UV/ozone cleaning, the mobility and sheet carrier density can be partially restored toward the as-grown values. The mobility is increased by about two times from ≈1000 cm2 V−1 s−1 for the contaminated samples to ≈2000 cm2 V−1 s−1 for the ozone cleaned ones.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Vacuum Science & Technology B, Nanotechnology and Microelectronics: Materials, Processing, Measurement, and Phenomena
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
