Abstract

In the paper, a non-contact vibration retrieval method was presented and the performance was analyzed based on linear frequency modulation continuous wave (LFMCW) radar. Firstly, the backscattered signal model of a vibrational target was introduced with the stop-go assumption. Then a vibration retrieval method was proposed by extracting phase based on the backscattered signal model of a vibrational target. The influence of noise and clutter on vibration retrieval was analyzed, and the signal noise ratio of vibration measurement was obtained. Finally, the validity of the performance analysis was verified by computer simulations. In addition, the experimental data acquired by LFMCW radar was used to test the proposed method.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.