Non-thermal recovery of a viscous oil with a surfactant-polymer process

Abstract

Listen

Translate article

The goal of this work is to improve recovery of a viscous oil reservoir at 70 °C using a non-thermal process. Polymer floods can improve sweep efficiency, but leave behind a residual oil saturation. A surfactant-polymer flood has the potential to improve both the sweep as well as the displacement efficiency. Phase behavior experiments with the viscous oil, water and surfactants were conducted to identify surfactants. 1D and 2D sandpack displacements were conducted to evaluate the efficacy of the process. Phase behavior experiments showed Winsor type I behavior with a low interfacial tension using a single surfactant, but not ultralow tension. Water flood recovered about 50% OOIP and reduced the oil saturation to about 45% in 1D floods. The subsequent SP flood increased the cumulative oil recovery to 99% in sandpacks when the viscosity of chemical slugs exceeded the oil viscosity. When the permeability decreased (as in a Bentheimer core), the oil recovery decreased to about 86%. Secondary SP floods also recovered most of the oil and faster than tertiary floods. Reduction of polymer concentration (and viscosity to about 1/4th of the oil viscosity) reduced the oil recovery, especially in 2D sandpack floods. Decrease in interfacial tension increased the requirement of polymer concentration to maintain flood front stability. This flood demonstrates the effectiveness of Winsor type I SP formulation for viscous oil, high permeability reservoirs. Such a SP process would reduce the carbon footprint of viscous oil recovery compared to that of thermal processes.