Non-linear mechanical behaviour of thermoplastic elastomeric materials and its vulcanizate under tension/tension fatigue deformation by fourier transform rheological studies

Abstract

Fourier transform (FT) rheology opens up novel frontiers in understanding non-linear mechanical behaviours of polymeric materials under sustained long-term dynamic load. The prediction of the exact point of appearance of a crack in a sample under dynamic mechanical strains of large amplitude and the fatigue analysis has been made possible to such degrees of precision, previously not possible through conventional rheological and mechanical analysis. In this work, the fatigue behaviour of a thermoplastic elastomeric material (TPE) and a thermoplastic vulcanizate (TPV) from thermoplastic polyurethane (TPU) and epichlorohydrin− ethylene oxide−allyl glycidyl ether (GECO) rubber is investigated by Fourier transform studies under oscillatory strain-controlled tensional test to understand the linear and non-linear mechanical behaviour. Fatigue analysis is performed through the fingerprint harmonics of the material’s stress response, i.e., the second and third harmonics, ( I 2/1 and I 3/1) to establish the stress nonlinearity, asymmetry, and the formation of macrocracks. Furthermore, these higher harmonics are fitted with the Neo-Hooke and Mooney-Rivlin model to fundamentally understand the mode of fatigue failure, and a close agreement between theoretical fitting and experimental outcomes is established. Strain-life curves were utilized for the thorough investigation of the fatigue behaviour of the specimens and more than 9-fold enhancement in the strain life of the TPV is observed over TPU at a strain amplitude of ∼1.05 indicating an increasing ductility. Finally, the necessity of FT rheology was further emphasised as it is observed that I 2/1 and I 3/1 harmonics are more sensitive towards fatigue response as compared to the storage modulus and the complex modulus. Henceforth, the FT rheology analysis has enabled the current study to efficiently establish the ductility of each individual specimens and for prediction of the dynamic service lifetime of the developed materials.