Abstract
AbstractSpray forming is of considerable interest for potential commercial production of superalloy forging and rolling preforms. The low degree of macro segregation and the relatively small grain size (25–40 μm) make this process look attractive for compositionally complex modern day nickel based superalloys. Both argon and nitrogen have been used successfully as the atomising gas. Argon atomisation has been used when little or no oxygen or nitrogen pickup is desired and when a small amount of argon filled porosity (∼1 vol.-%) can be tolerated. Nitrogen atomization has been used when a decrease in porosity is desired and when a small amount of nitrogen pickup can be tolerated. In this case, rather than staying in the pores, the nitrogen gas dissolves into the alloy and precipitates as submicrometre titanium and niobium carbonitrides. These precipitates have been observed to have little effect on key mechanical properties (tensile, creep, and fatigue). PM/0649
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
