Abstract
We describe a flexible, lightweight, reversible NO 2 vapor sensor based on resistance changes of a thin film of a doped conducting polymer, poly- o-toluidine, deposited on plastic substrates. Unlike the irreversible signals typically observed in organic films, signal reversibility in the concentration range 100–10 ppm is readily achieved using a short burst of UV irradiation at room temperature in ambient air without the aid of heating or pump down cycles. Interestingly, signal response is dependent on the organic solvent used to cast the polymer film with dipolar aprotic solvents yielding films showing a strong response. There are striking differences in electrical and electronic properties including morphology of films cast from different solvents. This phenomenon is traced to polymer chain conformation in solution that is preserved in the solid state (cast film) which opens a new structural vector to tailor sensor response and selectivity. This study also expands the use of conducting polymers for the detection of vapors that were previously believed to be chemically too aggressive.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.