New contact material for reduction of arc duration for dc application

Abstract

The phenomenon of arcing is the major cause of electrical contact degradation in electrical switches. Degradation involves contact erosion and/or welding. The use of special contact material and that of specific material processing may permit contact erosion to be reduced, in particular by shortening the arc duration. A short review of these approaches is presented in the first part of this paper. In the second part, the development of a new self-blowing contact material is described. This material has been tested under dc voltages from 14 V to 42 V. A reduction of the arc duration by a factor of 4 approximately was obtained as was a concomitant reduction of the extinction gap to less than 2 mm. This material will contribute to achieving better reliability in high current-high voltages breaking devices, and will aid in their miniaturization, e.g. in relays.