Abstract
In the past neutron radiography has been successfully applied to investigate the water transport behavior in polymer electrolyte fuel cells and its influence on overall cell performance [1-2]. The same technique can be also used to visualize the gas and water transport inside working polymer electrolyte membrane (PEM) electrolyzers. While it is obvious that under operating conditions, a two phase flow of water and its gaseous splitting products occurs inside the porous layers and the flow channels, it is not clear to what extent this can influence overall electrolysis cell performance. In theory gas bubble formation can block the catalyst surface on the anode, decreasing the overall efficiency In addition, the resulting inhomogeneity of the current density over the active area can lead to a local overheating and membrane damage. Strong attenuation of the neutron beam inside liquid water, as compared to typical electrolyzer materials like steel and titanium, makes neutron radiography a perfect technique to investigate these phenomena. Neutron radiograms of PEM electrolysis cells (1 cm2 active area) were obtained at varying working parameters. Our experimental setup is designed to provide maximal imaging capabilities at simulated local conditions which can occur in real scale devices. Special attention will be put to the water – gas transport perpendicular to the porous layer. Figure 1 shows the typical patterns with gradients of water thickness being little dependent on the operating conditions. This presentation is intended to provide the fundamentals about both the experimental possibilities as well as the water/gas transport behavior during PEM electrolysis cell operation, stimulating the development of numerical models describing this complex system.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call