Abstract
The development of continuously decreasing workpiece tolerances lies in one line with the perspective of nanotechnology. To fulfil metrological demands since about 1982 new high resolution and high precision measuring devices have been developed. These are computerized instruments and the measuring results are very illustrative figures of tested specimens. But the problem of calibration in the nanometric range is still an open question which normally is done only with high uncertainty. New ideas to find a solution for the problem of sufficiently accurate calibrating will make possible that this measurement technique will be used on a broad basis also in industry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
