Nano-mechanical exploration of the surface and sub-surface of hydrated cells of Staphylococcus epidermidis

Abstract

The surface of hydrated cells of Staphylococcus epidermidis has been probed using an atomic force microscope. While local force measurements over the surface of bacteria reveal a heterogeneous chemical surface, with heterogeneous mechanical properties, different kinds of force curves appear with high frequency, and are thought to provide information on features contributing strongly to the overall mechanical and surface behaviour of the cell. Force curves often present two different mechanical regimes, being the first one (outer) of about 48 nm thick, and presenting a local relative elasticity of about 0.08 N/m, which is about a third of the relative elasticity of the inner part of the cell wall, harder, with a relative elasticity of about 0.24 N/m, in water. Both regimes appears as straight lines in the force versus distance curves (the 'corresponding' stress-strain curves in contact mechanics), but hysteresis is observed between the approach and the retraction line in the inner regime, indicating a degree of viscoelasticity. No viscoelasticity is observed in the outer regime, however, which presents quite linear and juxtaposed approach-retraction lines. These kinds of force curves do not present measurable pull-off forces nor snap-in forces, which indicates an almost null interaction between tip and bacterial surface, which could be in agreement with the measured very high hydrophobicity of this strain. Another kind of force curve has been observed recurrently, showing peaks in the retraction curves. Adhesive pull-off forces were measured giving an average of about 2 nN. Interestingly, however, these force curves appear only when quite irregular and wavy retraction curves are present, from the very beginning of its trace (maximum indentation). This leads us to think that these pull-off forces measured by our AFM do not give information on surface forces-unbinding events at the surface of the bacteria, but could be related to events at the sub-surface of the cell surface. Oscillations seen in the retraction curve in the portion corresponding to the contact with the bacteria surface could be due to rupture phenomena within the multilayered cell wall architecture expected in Gram-positive bacteria as Staphylococcus epidermidis, which could result in local irreversible deformations of the cell surface. Imaging with a sharp tip in contact mode sometimes leads to surface damage. Force curves recorded over damaged parts of the cell surface showed a completely different behaviour, in many cases with two well-defined high-adhesion peaks, and also interestingly, with snap-in forces of about 0-2 nN, which seems to indicate a completely different electrical/hydrophobicity state only a few nanometers down from the surface. Similar indentation effects can occur in the contact of a bacterial cell with a solid surface, even when showing only atomic-molecular-scale roughness, thus interacting not only with the very surface of the cell, especially when soft layers are present in the outer. Our results highlight the importance of the cell surface mechanical properties and their interplay with purely surface properties when analyzing cell-material interaction, and show the AFM as a useful method for investigating this.