Nanoindentation plasticity and loading rate sensitivity of laser additive manufactured functionally graded 316L and 410L stainless steels

Abstract

The present work is the first to show the effect of processing cooling rate on phase structure and the resulting nano-scale deformation mechanisms in functionally graded stainless steels produced by directed energy deposition. To this end, fabrication by laser additive manufacturing involved implementing a closed-loop feedback control approach to monitor and control the peak temperature of the molten pool and the corresponding cooling rate. Single-track wall structures were produced from 316-L austenitic and 410-L martensitic stainless steels deposited using open-loop conditions with varying processing parameters (laser power and beam scanning speed) to produce graded microstructures. These were then compared to uniformly deposited layers where a constant cooling rate was maintained to generate homogenous microstructures using these two alloys, containing well-aligned columnar austenitic grains and random martensitic packets. Microstructural aspects (grains and crystallographic texture) across different layers (bottom, middle, and top) of the consolidated stainless steel walls (austenitic and martensitic) were compared under various processing conditions (without and with closed-loop or feedback control) and characterized using electron backscattering diffraction analysis. The nano-scale plastic deformation of these austenitic and martensitic stainless steel structures were assessed using nanoindentation testing over a range loading rates from 1 to 50 mN/s. The indentation response using varying strain rates was investigated based on the plastic flow indenting transition behavior at a high loading rate in order to correlate their dependence on microstructural features (predominantly for the martensitic phase). According to the rate sensitivity analyses, the gradient in grain structure (size and morphology) in the case of additively manufactured austenitic microstructure was not sensitive to loading rate, while the martensitic grains had a high local loading rate sensitivity.