Abstract
This paper describes the deformation of the sliding surfaces of a mechanical seal. That is, the values of the deformation due to the seal pressure and the oil film pressure are analyzed theoretically, in the analysis a mechanical seal is considered as a ring having rectangular section. Then the seal characteristics are tested by some analogical experiments in which a surface having the shape of theoretical deformation are used as a sliding surface of a mechanical seal.And the followings are obtained.1) The distribution of the oill film pressure between the sliding surfaces is varied by the deformed shape of the surfaces, then the necessary thrust force to seal the fluid is greatly influenced to the shape also.2) It is necessary to balance the moments arround the center of the axial section for decreasing the amount of the surface deformation.3) In the outside type seal a concave shaped surface which gives convex shape oil film pressure distribution shows more stable seal caracteristics than a plane shaped one.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Japan Society of Precision Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.