Abstract
This paper describes some experimental results with the influence of grinding stiffness, stiffness of grinding wheel and mechanical system on the grinding process as well as their characteristics. These results are summarized as follows.(1) The strongest correlation is observed between the grinding stiffness and the attritions wear (cutting edge ratio) of grinding wheel. Namely the grinding stiffness shows a rapid increase when the magnitude of cutting edge ratio reaches an almost constant value.(2) The stiffness of grinding wheel is considerably large as compared with the grinding stiffness or stiffness of mechanical system, then it can be considered that the elastic deformation of grinding wheel is negligible.(3) The actual depth of cut is affected remarkably by the stiffness of mechanical system.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Japan Society of Precision Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
