Abstract
Short stems have become increasingly popular in reverse shoulder arthroplasty (RSA) due to their ability to preserve bone stock for revision surgery. However, short stems may be more at risk for malalignment or loosening, and commercially available stems have varied designs. The purpose of this study was to perform a multiplanar analysis of proximal humerus anatomy in patients with rotator cuff arthropathy to better define canal geometry and identify differences based on sex. A retrospective review was performed of a consecutive series of patients undergoing RSA for rotator cuff arthropathy. A total of 117 patients were identified with preoperative computed tomography scans. Measurements were undertaken following multiplanar reconstruction of the computed tomography scans. Measured parameters included the following: transition point (TP), anteroposterior (AP) and mediolateral (ML) distances, intramedullary (IM) and bone diameter, and cortical thickness. The TP was defined as the distance from the periosteal border of the greater tuberosity to the level of the IM canal where the endosteal borders became parallel. Measurements started at the metaphysis, and then proceeded 25 and 50 mm distal to the metaphysis followed by 10 mm increments thereafter. Each level was compared to the level above with t tests in the overall cohort and separately by sex. Height was correlated to ML-AP difference and IM diameter with Pearson correlation coefficient. Potential stem sizes that extended 50, 60, 70, and 80 mm from the metaphysis were analyzed to record the percentage of patients in whom the stem would reach past the TP. The mean TP for all patients was 55.6±7.4 mm (37.5-78.4) from the greater tuberosity, 53.3±6.6 mm (37.5-67.0) in females and 58.1±7.5 mm (41.9-78.4) in males. ML and AP distances and IM diameter became consistent at level 3 (mean, 83 mm distal to the greater tuberosity) in the overall cohort and in both sexes. Height positively correlated with IM diameter. Males had significantly larger IM diameters compared to females at all levels. Cortical thickness remained relatively consistent throughout the proximal humerus. A stem length of 70 mm would extend past the TP in 98% of patients. Humeral implants in RSA with a stem of at least 70 mm in length would extend distally past the TP in the majority of cases regardless of sex. At this point, the canal's area remains consistent which would facilitate diaphyseal fixation if required.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.