Multi-Component Evaporation and Uneven Aluminum Distribution during High-Power Vacuum Laser Welding of Ti-6Al-4V Titanium Alloy

Abstract

Titanium alloy is an important material for the manufacture of key components of deep-sea submersibles. High-power vacuum laser welding is an important method for welding TC4 thick plate (40–120 mm) structures. However, due to the low melting point of aluminum, its uneven distribution in the weld caused by evaporation during welding affects the quality of joints. This paper conducted experimental and simulation studies to investigate the effect of process parameters on multi-component evaporation and uneven aluminum distribution. Based on a three-dimensional model of vacuum laser welding, the mechanism of the uneven distribution of aluminum in the weld is explained. The results show that the uneven distribution of aluminum in the weld is mainly related to the metal vapor behavior and keyhole morphology. As the welding speed rises from 1 m/min to 3 m/min, the proportion of aluminum in the metal vapor and the degree of compositional unevenness increase. When the laser power increases from 6 kW to 18 kW, the proportion of aluminum in the metal vapor and degree of unevenness increase, peak at 12 kW, and then decrease. This work facilitates the selection of suitable process parameters to reduce aluminum evaporation during the high-power vacuum welding of Ti-6Al-4V alloys. Joints with a more stable performance can be obtained by avoiding the uneven distribution of aluminum.