Abstract
We investigated the thermal properties, microphase separated structure and mechanical properties of a series of thermoplastic polyurethanes (TPUs) containing both polyisobutylene (PIB) and poly(tetramethylene oxide) (PTMO) diols in the soft segment (SS). A series of TPUs were prepared with the same weight fraction of the SS but different ratio between PIB and PTMO diols. Molecular weight of the PTMO diol and chemical structure of the hard segment (HS) also varied. Dynamic mechanical analysis (DMA) measurements did not reveal strong microphase separation between PIB and PTMO in the SS. While it has been assumed that incorporating PTMO diol into the SS can enhance the phase mixing between the hard segment (HS) and SS, our results indicated that, in most cases, the degree of microphase separation of TPUs based on mixed diols is slightly higher than that of TPUs based on only PIB diol.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
