Abstract
AbstractMorphology and mechanical properties of (amine terminated butadiene acrylonitrile rubber/diglycidyl ether of bis‐phenol‐A epoxy resin) blends of different compositions, cured in wide range of temperatures, are described. Curing at low temperature promoted formation of homogeneous materials with poor fracture resistance. On the contrary, at high temperature tough heterogeneous blends were obtained. Such blends showed phase inversion above 20 percent of rubber. The volume fraction of precipitated phase, determined on SEM micrographs, was higher than the amount of added rubber. A fracture mechanism to account for this is proposed. Extensive voiding and interface damage were observed in the low temperature cured materials. Such phenomena did not contribute to the fracture energy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.