Morphological and mechanical characterization of 3D printed PLA scaffolds with controlled porosity for trabecular bone tissue replacement

Abstract

Bone transplant is still the gold standard approach when dealing with orthopedic trauma or disease. When this solution is not possible, scaffolding is a possibility provided by bone tissue engineering. To support the regeneration process, damaged bone tissue is removed and replaced by porous scaffold structures. In recent years, additive manufacturing has shown huge potential to produce scaffold structures with the required performance. In the current work, PLA scaffolds with different designs were 3D printed, using optimal manufacturing parameters. Scaffolds with three different porosity values were obtained by changing the filament offset from 571 to 1333 μm. A total of twelve designs were tested under monotonic and dynamic compression conditions. Numerical analysis showed good correlation with experimental results, allowing for a better assessment of scaffold mechanical behavior. Stress relaxation was measured on four different strain levels, assessing scaffold's behavior after implantation and consequent static response over time. Overall, orthogonal design provided better performance, due to improved material deposition. With lower porosity scaffolds equilibrium stress reached 24 MPa after 300 s relaxation time under 4% deformation, and the obtained equilibrium modulus was 428 MPa. Overall, attained results show that 3D printing with PLA can be applied in the manufacture of scaffolds for trabecular bone replacement.