Abstract
AbstractThe monometallic complex [Pd(L)(PPh3)] (mono‐Pd) was synthesized using a potentially tridentate hydrazone (H2L) and used as precursor to prepare a heterobimetallic ruthenium (II)‐palladium (II) complex [Cl2(p‐cymene)Ru(μ‐L)Pd (PPh3)] (Ru‐Pd). Mono‐Pd and Ru‐Pd were characterized by fourier transform infrared spectroscopy (FTIR), ultraviolet‐visible spectroscopy (UV–Vis), 1H, 13C{1H} and 31P{1H} nuclear magnetic ressonance(NMR) spectroscopy, elemental analysis, cyclic voltammetry, matrix‐assisted laser desorption/ionization ‐ time of flight (MALDI‐TOF) mass spectrometry, and computational methods. The mono‐Pd was additionally studied by single‐crystal X‐ray diffraction. The complex [RuCl2(p‐cymene)(Isoniazid)] (mono‐Ru) was also obtained following literature methods aiming a comparison in the catalytic activity. The ring opening metathesis polymerization (ROMP) of norbornene (NBE) using mono‐Ru or Ru‐Pd as precatalysts in the presence of ethyl diazoacetate (EDA) was evaluated as a function of time (10–60 min) using [NBE]/[EDA]/[Ru] = 5000/28/1 at 50°C. The time increases produced good yields of polyNBE, reaching 38% and 46% for mono‐Ru and Ru‐Pd, respectively. The polyNBE produced was measured by size‐exclusion chromatography (SEC) and reached an order of magnitude of 105 g·mol−1 of Mn, with Ð values ranging from 2.51 to 1.86 for mono‐Ru and from 3.50 to 1.66 for Ru‐Pd. The catalytic activity of mono‐Pd and Ru‐Pd on ethylene polymerization was assessed with a range of [Al]/[Pd] molar ratio between 350 and 1750, 30–70°C temperature, 2 to 4 h reaction time, and total reaction volume of 25 and 50 ml. Mono‐Pd achieved an activity of 22.80 kg PE (mol Pd)−1 h−1 at 60°C after 4 h using [Al]/[Pd] = 1050, 7 μmol of catalyst in 25 ml of toluene, and 116 psi ethylene. For Ru‐Pd, an activity of 20.35 kg PE (mol Pd)−1 h−1 at 60°C after 4 h was obtained using [Al]/[Pd] = 1750, 7 μmol of catalyst in 25 ml of toluene, and 116 psi ethylene. Overall, Ru‐Pd showed to be active in both ROMP and ethylene polymerization reactions, being categorized as a bifunctional catalyst.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.