Modification of grain boundary microstructure by controlling dissolution behavior of θ particles in Cr-containing hypereutectoid steel

Abstract

Listen

Translate article

To overcome the brittleness of high‑carbon steels, it is necessary to develop the strategy to remove the carbides on the grain boundaries and strengthen grain boundaries. In this paper, we achieved them by simply controlling the heat treatment conditions and the microstructure before heat treatment. It was found the dissolution behavior of the θ-cementite particles is changed greatly with and without Cr in the high‑carbon steels. In the Cr-free hypereutectoid steel, dissolution of θ particles at high temperatures is remarkably fast, but the dissolution behavior is greatly affected by the microstructure in the Cr-containing hypereutectoid steel. In the Cr-containing hypereutectoid steel, the dissolution of θ particles into the γ-austenite phase was rapid in steel with smaller θ particles in fine α grains, but slow in steel with larger θ particles in coarse α grains. The θ particles on the grain boundaries preferentially dissolved and rapidly disappeared in the initial stage of the dissolution treatment owing to the contribution of grain boundary diffusion, since the grain boundary diffusion of Cr is fast as comparable to C. However, the θ particles inside the grains slowly dissolved and then remained until the later stage, owing to slow dissolution via the partition local equilibrium (PLE) mode controlled by the lattice diffusion of Cr. Owing to the preferential dissolution of θ particles on the grain boundaries in the initial stage, large amounts of Cr atoms dissociated from the θ particles diffused along the grain boundaries with grain boundary diffusion, forming Cr-enriched grain boundaries. Such grain boundary microstructure control is expected to lead to the suppression of intergranular fracture, resulting in the improvement of fracture toughness.