Abstract
In this paper simulation results of a spoke-type synchronous generator for a wind turbine with three different grades of Alnico magnets were presented. COMSOL Multiphysics 5.4 finite element analysis (FEA) based software was used. The proposed model was used for simulation of a synchronous generator with non-linear Alnico magnets with recoil-lines with some approximations and can be used for modelling electrical machines with other non-linear permanent magnets. The geometry of the machines was kept fixed for all scenarios. The model takes into account the irreversible loss of magnetization of non-linear permanent magnets due to the magnetic field from the stator winding during normal operation and short circuit. Modelling results show that Alnico 5 (ArKomax800) magnets have the lowest output power, but they are the least sensitive to change of the load. The generator with Alnico 8 permanent magnets have the highest output power, is good at handling the nominal load but the most sensitive to short circuits. Alnico 9 magnets could be an option if the risk for short circuits is accounted for.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.