Abstract
Thermoelectric pastes of stoichiometric Sb2Te3 and Bi2Te3 were prepared, characterized and used as active materials to fabricate a flexible heat sink free thermoelectric generator (TEG). The module was designed to be coupled to a 80mV start-up input voltage fully electrical DC-DC converter. Although practical aspects and technological limitations led to a not optimal dimensioning of the device, an improvement of its thermoelectric performance might be obtained by including an additional thick film metal layer on the two sides of TEG, as demonstrated by Finite Element Analysis (FEA) results. The designed thermopile consists of 450 thermocouples realized by blade coating of p- and n-type materials into 2mm tall vertical cavities of a pre-patterned Polydimethylsiloxane (PDMS) through-holes layer of total area 98×98mm2.For a first functional investigation, a prototype of 45 thermocouples into a footprint area of about 2.2×10−3m2 was fabricated and tested to evaluate its thermoelectric performance stand-alone and coupled with the DC-DC converter. A mean Seebeck coefficient of about 60μV/K for pn couple was calculated from experimental data, and a power of about 27nW was measured at 10K on matched load of about 6.8kΩ. A temperature difference of about 1.8°C was achieved between the junctions in working conditions next to those typical of human body wearing in indoors (quiescent air at room temperature, constant temperature of 34.8°C applied on the TEG hot side). The investigation shown that a thermopile of 450 couples requires a minimum thermal gradient of about 2°C between junctions to be able to switch on the custom voltage boost DC-DC converter.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call