Abstract

The magnetosphere is a major source of energy for the Earth's ionosphere and thermosphere (IT) system. Current IT models drive the upper atmosphere using empirically calculated magnetospheric energy input. Thus, they do not sufficiently capture the storm-time dynamics, particularly at high latitudes. To improve the prediction capability of IT models, a physics-based magnetospheric input is necessary. Here, we use the Open Global General Circulation Model (OpenGGCM) coupled with the Coupled Thermosphere Ionosphere Model (CTIM). OpenGGCM calculates a three-dimensional global magnetosphere and a two-dimensional high-latitude ionosphere by solving resistive magnetohydrodynamic (MHD) equations with solar wind input. CTIM calculates a global thermosphere and a high-latitude ionosphere in three dimensions using realistic magnetospheric inputs from the OpenGGCM. We investigate whether the coupled model improves the storm-time IT responses by simulating a geomagnetic storm that is preceded by a strong solar wind pressure front on August 24, 2005. We compare the OpenGGCM-CTIM results with low-earth-orbit satellite observations and with the model results of Coupled Thermosphere-Ionosphere-Plasmasphere electrodynamics (CTIPe). CTIPe is an up-to-date version of CTIM that incorporates more IT dynamics such as a low-latitude ionosphere and a plasmasphere, but uses empirical magnetospheric input. OpenGGCMCTIM reproduces localized neutral density peaks at approx. 400 km altitude in the high-latitude dayside regions in agreement with in situ observations during the pressure shock and the early phase of the storm. Although CTIPe is in some sense a much superior model than CTIM, it misses these localized enhancements. Unlike the CTIPe empirical input models, OpenGGCM-CTIM more faithfully produces localized increases of both auroral precipitation and ionospheric electric fields near the high-latitude dayside region after the pressure shock and after the storm onset, which in turn effectively heats the thermosphere and causes the neutral density increase at 400 km altitude.

Highlights

  • The magnetosphere is one of the major energy sources that drive the Earth’s upper atmosphere

  • Motivated by the coupled magnetosphere-ionosphere-thermosphere (CMIT) studies (Wang et al 2004, 2008, 2010; Lei et al 2008) and the Assimilative Mapping of Ionospheric Electrodynamics (AMIE)-Thermosphere Ionosphere Mesosphere Electrodynamics General Circulation Model (TIMEGCM) studies (Crowley et al 2010), this paper investigates the thermospheric responses of OpenGGCM-Coupled Thermosphere Ionosphere Model (CTIM) by simulating the geomagnetic storm on August 24, 2005

  • We run the OpenGGCM-CTIM and Coupled Thermosphere-Ionosphere-Plasmasphere electrodynamics (CTIPe) models to reproduce the thermospheric mass density observed by Challenging Minisatellite Payload (CHAMP) and Gravity Recovery and Climate Experiment (GRACE) during the geomagnetic storm on August 24, 2005

Read more

Summary

Introduction

The magnetosphere is one of the major energy sources that drive the Earth’s upper atmosphere. Crowley et al (2010) ingested the AMIE electric fields into the Thermosphere Ionosphere Mesosphere Electrodynamics General Circulation Model (TIMEGCM), and reproduced the high-latitude thermospheric density enhancement observed by the Challenging Minisatellite Payload (CHAMP) spacecraft after a sudden increase of IMF By, while Schlegel et al (2005) failed to simulate a similar density enhancement by using the same IT model but with empirical magnetospheric. This paper highlights the importance of including physics-based magnetospheric input parameters in the IT simulation

OpenGGCM-CTIM
Results and discussion
Summary and concluding remarks
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call