Abstract
Powder capture efficiency is indicative of the amount of material that is added to the substrate during laser additive manufacturing processes, and thus, being able to predict capture efficiency provides capability of predictive modeling during such processes. The focus of the work presented in this paper is to create a numerical model to understand particle trajectories and velocities, which in turn allows for the prediction of capture efficiency. To validate the numerical model, particle tracking velocimetry experiments at two powder flow rates were conducted on free stream particle spray to track individual particles such that particle concentration and velocity fields could be obtained. Results from the free stream comparison showed good agreement to the trends observed in experimental data and were subsequently used in a direct laser deposition simulation to assess capture efficiency and temperature profile at steady-state. The simulation was validated against a single track deposition experiment and showed proper correlation of the free surface geometry, molten pool boundary, heat affected zone boundary and capture efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.