Abstract
In the current research, a coupled Eulerian and Lagrangian method is used to model the friction stir welding process. Volume of fluid principle is used to predict the formation of defects during the process. Model is validated with experimentally observed spindle torque and axial force. Three different pin heights were simulated and pin height of 2.5 mm was found as the optimum value. Experimental defects are observed using the X-ray computer tomography method. The model has successfully predicted the presence of defect for different welding parameters. Defect free weld is produced at a tilt angle of 2°. Qualitative comparisons of effective plastic strain and welding efficiency were carried out and correlation among them is proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
