Abstract

The load demand to a power grid, as well as the interest in clean and low-cost energy resources, has led to the high integration of wind power plants into power system grids. There are grid code standards that are set for the design and integration of these wind power plants. These codes often look at the design operation of the wind power plant in islanded mode, where possible analysis of the most sensitive power system quantities such as voltage, frequency, reactive power, etc. is carried out. Therefore, in this study, attention was paid to the application of these codes to keep the design and integration of wind power plants well standardized as much as possible. The purpose of this paper is to review and discuss the literature and theory about the design of wind turbine generators and model and simulate a large-scale wind power plant. The modeling was successfully carried out on RSCAD, and the results obtained show that the wind power plant can be further used for other studies such as voltage stability improvement in power grids.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.